Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- If DTC P0102, P0103, or P0405 are set, diagnose these DTC first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Verify the integrity of the entire air induction system by inspecting for the following conditions:
- Restrictions in the MAF air induction system and the turbocharger system
- Restrictions in the exhaust system-Refer to Restricted Exhaust .
- Leaks at the MAF/IAT sensor O-ring seal
- Cracked or damaged MAF sensor housing
- Restricted intake air duct or a dirty air filter element
- Debris blocking the air sensing filaments of the MAF sensor
- Snow or ice build-up in cold climates at the air cleaner, MAF, or MAP sensor do not exist.
- Engine running, observe the DTC information with a scan tool. DTC P0101 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame Records data.