LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System & Fuel System - 6.6L (LLY) - DTC P0016 To DTC P0341) >> DTC P0045 >> Repair Verification

Repair Verification

WARNING: This page is about a different variant/trim than selected.
  1. Engine running, observe the scan tool TC Vane Position Sensor and the Desired TC Vane Position parameters. Slowly increase the engine speed to 2,500 RPM, and slowly return the engine speed to idle. The TC Vane Position parameter should remain near or equal to the Desired TC Vane Position parameter.
  2. Engine running, observe the scan tool TC Vane Position Sensor parameter while increasing the engine speed to 1,500 RPM and maintaining. Command the TC Vane Pos. Ctrl. Solenoid ON and OFF. The TC Vane Position Sensor parameter should increase to 95-97 percent when the TC solenoid is commanded ON, and decrease to near 0 percent when commanded OFF.
  3. Engine running, observe the scan tool TC Vane Position Sensor and the Desired TC Vane Position parameters while increasing the TC vane position sensor in 5 percent increments from 0-100 percent. The TC Vane Position Sensor and the desired TC Vane Position parameters should remain within 2 percent of each other during the entire range.
scientia non olet · About LEMON Manuals