LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Ensure that the MAF sensor flow arrows point away from the air cleaner assembly.
  1. Install the MAF sensor (5) into the air intake ducts.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Tighten the clamps (1) on the MAF sensor.

    Tighten:  Tighten the clamps to 4 N.m (35 lb in).

    3. Fig 1: Water Outlet Stud Ground Wire
    GM712012Courtesy of GENERAL MOTORS CORP.
  3. Connect the MAF sensor harness connector.
scientia non olet · About LEMON Manuals