LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.

The knock sensor (KS) is located at the top rear of the engine.

    CAUTION: Refer to BATTERY DISCONNECT CAUTION .
  1. Disconnect the negative battery cable.
  2. Remove the engine cover. Refer to Engine Cover Replacement .
    3. Fig 1: Locating Knock Sensor & Retaining Bolt
    GM679284Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the KS harness connector (3).
  4. Remove the KS bolt (1).
  5. Remove the KS (2).
scientia non olet · About LEMON Manuals