LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Knock Sensor & Retaining Bolt
    GM679284Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to COMPONENT FASTENER TIGHTENING NOTICE .
  1. Install the knock sensor (2) and bolt (1).

    Tighten:  Tighten the knock sensor bolt to 25 N.m (18 lb ft).

  2. Connect the KS harness connector (3).
  3. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals