LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Ignition Control Module Assembly
    GM690078Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the ignition control module (2) and the heat sink (1) on the bracket with the screws (4).

    Tighten:  Tighten the screws to 3.5 N.m (31 lb in).

  2. Reconnect the electrical connectors (3).
  3. Install the engine cover. Refer to Engine Cover Replacement .
  4. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals