LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  2. Remove the engine cover. Refer to Engine Cover Replacement .
  3. Disconnect the ignition coil electrical connectors.
  4. Remove the ignition coil wire to the distributor.
    5. Fig 1: Cruise Control Cable & Cable Bracket
    GM580239Courtesy of GENERAL MOTORS CORP.
  5. Using a suitable tool disconnect the cruse control cable from the throttle body.
    6. Fig 2: Identifying Accelerator Cable/Throttle Body Lever
    GM325556Courtesy of GENERAL MOTORS CORP.
  6. disconnect the accelerator control cable from the throttle lever.
    7. Fig 3: View Of Accelerator Cable Bracket
    GM398027Courtesy of GENERAL MOTORS CORP.
  7. Remove the accelerator cable bracket and position aside.
    8. Fig 4: View Of Ignition Coil, Bracket & Studs
    GM31466Courtesy of GENERAL MOTORS CORP.
  8. Remove the studs holding the bracket and the ignition coil to the intake manifold.
  9. Remove the bracket and the ignition coil.
  10. Drill and punch out the two rivets holding the ignition coil to the bracket.
  11. Remove the ignition coil from the bracket.
scientia non olet · About LEMON Manuals