LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: A replacement ignition coil kit comes with 2 screws in order to attach the ignition coil to the bracket.
  1. Install the ignition coil to the bracket with the 2 screws.
    2. NOTE: Refer to Fastener Notice .
    Fig 1: View Of Ignition Coil, Bracket & Studs
    GM31466Courtesy of GENERAL MOTORS CORP.
  2. Install the ignition coil and the bracket to the intake manifold with studs.

    Tighten:  Tighten the studs to 11 N.m (97 lb in).

    3. Fig 2: View Of Accelerator Cable Bracket
    GM398027Courtesy of GENERAL MOTORS CORP.
  3. Install the accelerator control bracket.

    Tighten:  Tighten the accelerator control cable bracket nuts and studs to 12 N.m (106 lb in).

    4. Fig 3: Identifying Accelerator Cable/Throttle Body Lever
    GM325556Courtesy of GENERAL MOTORS CORP.
  4. Connect the accelerator control cable to the throttle cable.
    5. Fig 4: Cruise Control Cable End And Throttle Linkage
    GM580222Courtesy of GENERAL MOTORS CORP.
  5. Connect the cruse control cable (2) to the throttle linkage.
    6. Fig 5: View Of Ignition Coil Wire Harness
    GM387772Courtesy of GENERAL MOTORS CORP.
  6. Install the ignition coil wire.

    The wire must not touch anything like the dip stick. Rubbing will make a ground or short after time of use.

  7. Install the electrical connectors.
  8. Install the engine cover. Refer to Engine Cover Replacement .
  9. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals