LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of fuel pressure sensor
    GM1824611Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel pressure sensor (1).
  2. Install the fuel tank. Refer to Fuel Tank Replacement (Passenger/Cargo Van) .
  3. Refill the fuel tank.
  4. Install the fuel filler cap.
  5. Connect the negative battery cable.
  6. Inspect for leaks:
    1. Turn ON the ignition for 2 seconds.
    2. Turn OFF the ignition for 10 seconds.
    3. Turn ON the ignition.
    4. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals