LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pulse Dampener Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Exploded View Of Fuel Meter Body Assembly
    GM1655471Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the NEW O-ring with clean engine oil.
  2. Install the fuel pressure dampener O-ring seal (5).
  3. Install the fuel pressure dampener (6).
  4. Install the fuel pressure dampener retaining clip (7).
  5. Install the upper manifold. Refer to Upper Intake Manifold Replacement .
  6. Tighten the fuel fill cap.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  8. Inspect for leaks.
    1. Turn the ignition ON, for 2 seconds.
    2. Turn the ignition OFF, for 10 seconds.
    3. Turn the ignition ON.
    4. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals