LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of fuel pressure sensor
    GM1824647Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to BATTERY DISCONNECT CAUTION .
  1. Disconnect the negative battery cable.
  2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027)  or Fuel Pressure Relief (Without CH 48027) .
  3. Drain the fuel tank. Refer to Fuel Tank Draining .
  4. Remove the fuel tank. Refer to Fuel Tank Replacement (Passenger/Cargo Van) .
  5. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
  6. Disconnect the fuel pump electrical connector.
  7. Remove the electrical connector retaining clip from the fuel level sensor.
  8. Disconnect the electrical connector from the fuel level sensor under the fuel sender cover.
  9. Remove the retaining clip from the fuel level sensor.
  10. Squeeze the locking tangs and remove the fuel level sensor (1).
scientia non olet · About LEMON Manuals