LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of fuel pressure sensor
    GM1824647Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel level sensor (1).
  2. Install the retaining clip to the fuel level sensor.
  3. Connect the electrical connector to the fuel level sensor.
  4. Connect the electrical connector retaining clip to the fuel level sensor.
  5. Connect the fuel pump electrical connector.
  6. Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
  7. Install the fuel tank. Refer to Fuel Tank Replacement (Passenger/Cargo Van) .
  8. Refill the fuel tank.
  9. Install the fuel filler cap.
  10. Connect the negative battery cable.
  11. Inspect for leaks:
    1. Turn ON the ignition for 2 seconds.
    2. Turn OFF the ignition for 10 seconds.
    3. Turn ON the ignition.
    4. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals