LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Tank Components
    GM601669Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel feed and return pipes (6) to the fuel sender (1).
  2. Install the fuel tank. Refer to Fuel Tank Replacement (Passenger/Cargo Van) .
  3. Lower the vehicle.
  4. Refill the fuel tank.
  5. Tighten the fuel filler cap.
  6. Connect the negative battery cable.
  7. Inspect for leaks:
    1. Turn ON the ignition for 2 seconds.
    2. Turn OFF the ignition for 10 seconds.
    3. Turn ON the ignition.
    4. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals