LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement (w/Rear Tank) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Filler Pipe Assembly
    GM1198972Courtesy of GENERAL MOTORS CORP.
  1. Clean all the fuel pipe and hose connections and the surrounding areas before disconnecting in order to avoid contamination of the fuel system.
  2. Remove the fuel filler cap.
  3. Drain the fuel below the level of the fuel tank fill hose. Refer to Fuel Tank Draining .
  4. Remove the 2 retaining bolts and push-pin that retain the filler neck to the body.
  5. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove the fuel filler tube ground strap bolt.
  7. Loosen the fuel fill hose to fuel fill pipe clamp.
  8. Disconnect the fuel fill hose from the fuel fill pipe.
  9. Remove the fuel fill pipe assembly.
scientia non olet · About LEMON Manuals