LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement (w/LH Door) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Fill Hose
    GM1198965Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel fill pipe to the fuel fill hose.
    2. NOTE: Refer to Fastener Notice .
  2. Align the fuel fill pipe to the fuel fill pipe housing.

    Tighten:  Tighten the fuel fill hose clamp to 2.75 N.m (24 lb in).

  3. Install the fuel filler tube ground strap bolt.

    Tighten:  Tighten the fuel filler tube ground strap bolt to 8 N.m (70 lb in).

  4. Lower the vehicle.
  5. Install the fuel fill pipe housing bolts and push-pin.

    Tighten:  Tighten the fuel fill pipe housing bolts to 6 N.m (53 lb in).

  6. Refill the fuel tank.
  7. Install the fuel filler cap.
scientia non olet · About LEMON Manuals