LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Chassis/Canister >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Hoses/Pipes (Canister/Fuel Tank)
    GM396067Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the fuel sender EVAP pipe and the fuel tank roll over valve.
  2. Position the EVAP vapor pipe on the fuel tank.
  3. Connect the EVAP vapor pipe (1) to the fuel sender (2), the fuel tank roll over valve (3), and the fuel tank clips (6).
    4. Fig 2: View Of Fuel Tank & Straps
    GM300138Courtesy of GENERAL MOTORS CORP.
  4. Install the fuel tank. Refer to Fuel Tank Replacement (Passenger/Cargo Van) .
scientia non olet · About LEMON Manuals