LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Evaporative Emission (EVAP) Purge Pipe
    GM309184Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine cover. Refer to Engine Cover Replacement .
  2. Disconnect the evaporative emission (EVAP) purge pipe.
    3. Fig 2: Identifying EVAP Canister Purge Valve Harness Connector
    GM309181Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the purge valve electrical connector.
    4. Fig 3: View Of Purge Solenoid Nuts
    GM309187Courtesy of GENERAL MOTORS CORP.
  4. Remove the purge valve mounting nuts.
  5. Remove the engine wiring harness bracket from the mounting stud.
    6. Fig 4: View Of Purge Solenoid
    GM309179Courtesy of GENERAL MOTORS CORP.
  6. Remove the purge valve from the intake manifold.
scientia non olet · About LEMON Manuals