LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Perform the CKP system variation learn procedure whenever the crankshaft position (CKP) sensor is removed or replaced. Refer to Crankshaft Position System Variation Learn .
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Identifying CKP Sensor Harness Connector
    GM10937Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the CKP sensor harness connector.
    3. Fig 2: View Of CKP Sensor Bolt
    GM10938Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor mounting bolt.
    4. Fig 3: View Of CKP Sensor & Bolt
    GM11485Courtesy of GENERAL MOTORS CORP.
  4. Remove the CKP sensor.
scientia non olet · About LEMON Manuals