LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Repair Instructions >> Instrument Cluster Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Instrument Cluster & Screws
    GM328138Courtesy of GENERAL MOTORS CORP.
  1. Position the instrument cluster (1) to the vehicle.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the screws (2) that retain the instrument cluster to the instrument panel carrier.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  3. Install the instrument panel cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
  4. Tilt the steering column to the up position, if equipped with tilt steering.
  5. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  6. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals