3-5 and Reverse Clutch Plate Installation

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of 3-5 Reverse Clutch Plates 7 Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	3-5 Reverse Clutch Apply Ring NOTE: Ensure apply ring legs are positioned into the 3-5 reverse clutch piston. Failure to do so may cause damage to the 3-5 reverse clutch assembly.
2	3-5 Reverse Clutch (Waved) Plate
3	3-5 Reverse Clutch Plate (Quantity: 4)
4	3-5 Reverse Clutch Plate Assembly (Quantity: 4)
5	3-5 Reverse Clutch Backing Plate
6	3-5 Reverse Clutch Backing Plate Retaining Ring NOTE: Align the retaining ring gap with the missing snap ring groove punch in the housing. Failure to do so may cause damage to the clutch assembly. Tip: After the retaining ring is installed, determine clutch piston travel in order to verify if the correct selective retaining ring is being used. Refer to 3-5 Reverse Clutch Backing Plate Retaining Ring Measurement .