1-2-3-4 and 3-5 Reverse Clutch Bearing Assembly Replacement

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of 1-2-3-4 & 3-5 Reverse Clutch Bearing Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	3-5 Reverse Clutch Bearing NOTE: Install the NEW bearing assembly with the seal side up. Improper installation of the bearing may cause damage to the transmission. NOTE: Do not reuse the bearing. Install a NEW bearing. Reusing an old bearing may cause damage to the transmission. Specification: Install the bearing flush to 0.3 mm below the thrust surface. Special Tools DT 47865 Bearing Remover. See Special Tools . DT 47866 Bearing Installer. See Special Tools . J 8092 Driver Handle J 45124 Removal Bridge. See Special Tools .

Callout

Component Name

3-5 Reverse Clutch Bearing

NOTE: Install the NEW bearing assembly with the seal side up. Improper installation of the bearing may cause damage to the transmission.

NOTE: Do not reuse the bearing. Install a NEW bearing. Reusing an old bearing may cause damage to the transmission.

Specification: Install the bearing flush to 0.3 mm below the thrust surface.

Special Tools

DT 47865 Bearing Remover. See Special Tools .
DT 47866 Bearing Installer. See Special Tools .
J 8092 Driver Handle
J 45124 Removal Bridge. See Special Tools .