LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Avalanche 5.3 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 892 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Park Lock Pawl and Actuator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Parking Pawl Assembly
    GM43309Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission filter. Refer to Automatic Transmission Fluid and Filter Replacement .
  2. Remove the park/neutral position (PNP) switch. Refer to Park/Neutral Position Switch Replacement .
  3. Remove the manual shaft nut and pin.
  4. Remove the detent lever and actuator.
  5. Remove the parking pawl bracket bolts.
  6. Remove the parking pawl return spring.
  7. Use the modified screw extractor in order to remove the plug.
  8. Remove the parking pawl shaft retainer, shaft and pawl.
    9. IMPORTANT: If the manual shaft binds in the case during removal, file or sand the shaft in the area adjacent to the detent lever.
  9. Remove the manual shaft.
  10. Remove the manual shaft seal.
scientia non olet · About LEMON Manuals