Rear Side Door Trim Panel Replacement (Suburban/Yukon XL/Escalade ESV)

Fig 1: View Of Rear Side Door Trim Panel Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove rear door window control switch. Refer to Rear Side Door Window Switch Replacement .
1	Detent Tab
2	Rear Side Door Locking Rod Knob Assembly Tip: Lower window. Ensure locking rod is in the unlocked position. Use a flat-bladed tool to disengage detent tab, then remove knob by pulling upward. When re-installing, push knob down, until detent tab touches locking rod opening cover. Push detent tab in to lock knob to locking rod.
3	Rear Side Door Trim Panel Cover
4	Rear Side Door Trim Panel Cover Retainer (Qty: 4)
5	Rear Side Door Inside Handle Bezel Cover
6	Rear Side Door Trim Panel Bolt (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
7	Rear Side Door Trim Panel Assembly
8	Rear Side Door Cable Retainer Tip: Pull upward to disengage.
9	Rear Side Door Trim Panel Retainer (Qty: 10)