LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Avalanche 5.3 3 >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Weatherstrip Replacement - Midgate - Lower >> Installation Procedure

Installation Procedure

    Fig 1: Midgate Lower Weatherstrip
    GM787958Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: To begin the installation of the weatherstrip, ensure the weatherstrip is at a minimum of 21°C (70°F).
  1. Starting from one end of the weatherstrip, install the weatherstrip.
  2. Ensure the corners of the weatherstrip are fully seated.
  3. Install the floor hinge molding.
  4. Install the midgate. Refer to Midgate Replacement .
  5. Close the midgate.
  6. Install the rear removable rear glass panel.
  7. Inspect the weatherstrip when the midgate is closed and the glass panel installed.
  8. Set the rear seat in the upright position.
scientia non olet · About LEMON Manuals