LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Avalanche 5.3 3 >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Lid Replacement - Cargo Box Stowage Box >> Installation Procedure

Installation Procedure

    Fig 1: View Of Cargo Stowage Box & Bolts
    GM1708946Courtesy of GENERAL MOTORS CORP.
  1. Position the cargo box stowage lid (3) to the vehicle.
    2. IMPORTANT: Ensure that the feather edge is properly sealed to the glass and side panels.
  2. Install the cargo box water run channel.
    3. Fig 2: View Of Cargo Stowage Box & Bolts
    GM1708946Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the bolts to the cargo box stowage lid (1).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  4. Install the bolt inside the cargo box stowage lid assembly (2).

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  5. Install the cargo box bridge side inner panel. Refer to Panel Replacement - Cargo Box Bridge Side Inner (Avalanche)  or Panel Replacement - Cargo Box Bridge Side Inner (Escalade EXT) .
  6. Install the assist handle. Refer to Assist Handle Replacement - Endgate (Avalanche) .
  7. Install the cargo box cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
  8. Close the endgate.
scientia non olet · About LEMON Manuals