Hood Replacement

Fig 1: View Of Hood & Bolts

Courtesy of GENERAL MOTORS CORP.

Hood Replacement

Callout	Component Name
CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. Preliminary Procedure Disconnect the hood strut rod. Refer to Hood Strut Replacement . Remove the air inlet panel end panels. Refer to Air Inlet Grille Panel Replacement .
1	Hood Bolts (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 25 N.m (18 lb ft)
2	Hood Tip: Disconnect the electrical connector.

Callout

Component Name

CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Preliminary Procedure

Disconnect the hood strut rod. Refer to Hood Strut Replacement .
Remove the air inlet panel end panels. Refer to Air Inlet Grille Panel Replacement .

Hood Bolts (Qty: 2)

NOTE: Refer to Fastener Notice .

Tighten: 25 N.m (18 lb ft)

Hood
Tip: Disconnect the electrical connector.