LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement (Pickup) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. If the vehicle is equipped with a 8 ft box, install the CVS to the fuel tank until the clip engages.
    IMPORTANT: On vehicles equipped with a 8 ft box, the CVS line is routed below the frame crossmember.
    Fig 1: CVS Line & Clips (8 Ft Box - Pickup)
    GM1228109Courtesy of GENERAL MOTORS CORP.
  2. Install the CVS clip to the frame crossmember.
  3. Connect the EVAP CVS line to the canister.
  4. If the vehicle is equipped with a 6 ft box, install the CVS to the fuel tank until the clip engages.
    IMPORTANT: On vehicles equipped with a 6 ft box, the CVS line is routed above the frame crossmember.
    Fig 2: CVS Line & Clips (6 Ft Box - Pickup)
    GM1228107Courtesy of GENERAL MOTORS CORP.
  5. Install the CVS clip to the frame crossmember.
  6. Connect the EVAP CVS line to the canister.
  7. Connect the CVS electrical connector.
    Fig 3: Connecting CVS Electrical Connector
    GM1228110Courtesy of GENERAL MOTORS CORP.
  8. Install the harness clip to the canister vent solenoid (CVS) line.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals