Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: EVAP Canister Purge

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the EVAP canister purge valve.
Install the EVAP canister purge valve bolt.
Tighten: Tighten the bolt to 10 N.m (89 lb in).
Connect the EVAP purge tube to the purge solenoid.

Fig 2: View Of EVAP Purge Tube At Purge Solenoid
Courtesy of GENERAL MOTORS CORP.
Connect the EVAP canister purge valve electrical connector (1).

Fig 3: View Of Generator, Injector Harness, Ignition Coil Harness, ETC & Purge Valve Solenoid Electrical Connectors
Courtesy of GENERAL MOTORS CORP.
Install the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.