LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  2. Disconnect the evaporative emission (EVAP) canister purge solenoid valve tube (1) from the valve (2).
    Fig 1: Disconnecting EVAP Canister Purge Solenoid Valve Tube
    GM1501881Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the purge solenoid electrical connector (1).
    Fig 2: Disconnecting Purge Solenoid Electrical Connector
    GM1502053Courtesy of GENERAL MOTORS CORP.
  4. Remove the purge solenoid nut.
  5. Remove the engine wiring harness bracket from the stud.
  6. Remove the purge solenoid stud.
    Fig 3: Removing Purge Solenoid
    GM1503010Courtesy of GENERAL MOTORS CORP.
  7. Remove the purge solenoid from the intake manifold.
scientia non olet · About LEMON Manuals