LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 963 (Engine Mechanical - 6.6L (4 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 4) >> Valve and Seat Grinding

Valve and Seat Grinding

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Grinding Valve
    GM663566Courtesy of GENERAL MOTORS CORP.
  1. Remove the carbon from the valve guide and valve seat surface.
  2. Resurface the valve face to 45 degrees. If valve margin falls below specifications after resurfacing then discard valve.
  3. Use a suitable tool to bring the valve contact width to the standard value. The valve seat angle is 45 degrees.
    4. Fig 2: Turning Valve Back & Forth
    GM663569Courtesy of GENERAL MOTORS CORP.
  4. Apply valve lapping compound to the valve seat surface.
  5. Insert the valve into the cylinder head.
  6. Turn the valve back and forth in its seat to lap the valve face to the valve seat.
scientia non olet · About LEMON Manuals