LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 963 (Engine Mechanical - 6.6L (4 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 4) >> Engine Front Cover Cleaning and Inspection

Engine Front Cover Cleaning and Inspection

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Front Cover O-Ring
    GM663614Courtesy of GENERAL MOTORS CORP.
  1. Remove the O-ring (1) from the engine front cover.
  2. Remove the oil pressure relief valve from the engine front cover.
  3. Clean the engine front cover.
  4. Clean the engine front cover mating surfaces.
  5. Inspect the engine front cover mating surfaces for damage.
  6. Inspect the engine front cover O-ring sealing surface for damage.
  7. Inspect the crankshaft front oil seal bore for damage.
  8. Replace the engine front cover if any damage is found.
    9. Fig 2: View Of Pressure Relief Valve O-Ring
    GM793901Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  9. Install the oil pressure relief valve with a new O-ring.

    Tighten:  Tighten the oil pressure relief valve to 39 N.m (29 lb ft).

scientia non olet · About LEMON Manuals