LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 960 (Engine Mechanical - 6.6L (2 Of 5)) >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right Side Idler & Center Idler Pulley Bolts
    GM1409331Courtesy of GENERAL MOTORS CORP.
  1. Remove the drive belt. Refer to Drive Belt Replacement .
  2. Remove the bolt (1) from the right side idler pulley.
  3. Remove the idler pulley.
  4. Remove the bolt (2) for the center idler pulley.
  5. Remove the idler pulley.
  6. If equipped with dual generators, remove the bolt from the left side idler pulley.
  7. If equipped with dual generators, remove the idler pulley.
scientia non olet · About LEMON Manuals