LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 954 (Transfer Case - Mp 1222/1225/1226-NQG) >> Repair Instructions - Off Vehicle >> Shift Detent Lever Bearing Replacement

Shift Detent Lever Bearing Replacement

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Inner & Outer Shift Detent Lever Bearings
GM1843595Courtesy of GENERAL MOTORS CORP.
Shift Detent Lever Bearing Replacement

Callout Component Name

Preliminary Procedure

  • Using the J 7079-2  , remove the bearings from the front case half. See Special Tools .
  • Ensure the bearings are installed squarely into the bearing bores.
1 Transfer Case Shift Detent Lever Bearing - Inner
Tip: 
  • Ensure the printing on the bearing is facing upward.
  • Install the bearing using the long side of the DT-48215  . See Special Tools .
  • Press the bearing until the tool bottoms on the front case half.

Special Tools

  • DT-48215  Shift Detent Lever Bearing Installer. See Special Tools .
  • J 7079-2  Universal Driver Handle - Non-Threaded. See Special Tools .
2 Transfer Case Shift Detent Lever Bearing - Outer
Tip: 
  • Ensure the printing on the bearing is facing upward.
  • Install the bearing using the short side of the DT-48215  . See Special Tools .
  • Press the bearing until the tool bottoms on the front case half.

Special Tools

  • DT-48215  Shift Detent Lever Bearing Installer. See Special Tools .
  • J 7079-2  Universal Driver Handle - Non-Threaded. See Special Tools .
scientia non olet · About LEMON Manuals