LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 902 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal and/or Bearing Replacement (w/Rear Drum) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Axle Shaft Seal & Bearing
    GM1483194Courtesy of GENERAL MOTORS CORP.
  1. Remove the axle shaft. Refer to Rear Axle Shaft Replacement (8.6, 9.5/9.5LD Inch Axles)  or Rear Axle Shaft Replacement (8.6 Inch Axle w/Drum Brakes) .
  2. Remove the axle shaft seal and the bearing from the axle housing using the J 44685  (1) and the J 2619-01  (2). See Special Tools .
scientia non olet · About LEMON Manuals