LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 902 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal and/or Bearing Replacement (w/Rear Drum) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Axle Shaft Bearing
    GM1483687Courtesy of GENERAL MOTORS CORP.
  1. Install the axle shaft bearing using the J 23690  (1) and the J 8092  (2).
  2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
    3. Fig 2: Installing Axle Shaft Seal
    GM1483200Courtesy of GENERAL MOTORS CORP.
  3. Install the axle shaft seal using the J 21128  .
  4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
  5. Install the axle shaft. Refer to Rear Axle Shaft Replacement (8.6, 9.5/9.5LD Inch Axles)  or Rear Axle Shaft Replacement (8.6 Inch Axle w/Drum Brakes) .
scientia non olet · About LEMON Manuals