LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 880 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission System Hoses/Pipes Replacement (15 Ext/Crew Cab w/26 gal Tank) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean all fuel and evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the lines in order to avoid possible fuel and/or EVAP system contamination.
    Fig 1: EVAP Pipe Quick Connect Fitting
    GM1854689Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (15 Reg Cab w/26 Gal Tank)  or Fuel Tank Replacement (15 Ext/Crew Cab w/26 gal Tank)  or Fuel Tank Replacement (25 Ext/Crew Cab w/26 gal Tank)  or Fuel Tank Replacement (15/25 Reg/Ext/Crew Cab w/34 gal Tank)  or Fuel Tank Replacement (35 Reg/Ext/Crew Cab w/34 gal Tank) .
  2. Disconnect the EVAP pipe quick connect fittings from the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Remove the EVAP pipe from the fuel tank clips (1).
    4. Fig 2: Fuel Tank Clips
    GM1854690Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the EVAP pipe quick connect fittings from the rollover valve and the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Remove the EVAP pipe from the fuel tank clips (1 and 2).
scientia non olet · About LEMON Manuals