Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Using DT-47770 installer, install the transmission fluid cooler pipe seals (1) in the transmission.
- Install transmission fluid cooler pipes (1) the to the transmission.
- Install the transmission fluid cooler pipe bolt (2) to the transmission and tighten to 22 (16 lb ft).
- Install the left catalytic converter. Refer to Catalytic Converter Replacement (with Exhaust Clamp) .
- Lower the vehicle.
- Check the transmission fluid level.
CAUTION:
Refer to Fastener Caution .