LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1732 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Oil Pump Body Disassemble

Oil Pump Body Disassemble

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Pump Slide Outer Spring
    GM1462831Courtesy of GENERAL MOTORS CORP.
  1. Remove the pump slide outer spring (245).
  2. Place a rag over the spring while removing to prevent the spring from flying out.
    3. Fig 2: Identifying Oil Pump Rotor & Pump Vane Rings
    GM1552937Courtesy of GENERAL MOTORS CORP.
  3. Remove the oil pump rotor (212) and pump vane rings (210).
  4. Remove the pump vanes (213).
  5. Remove the rotor guide (211).
    6. Fig 3: Identifying Oil Pump Slide, Pump Slide Support Seal & Pump Slide Seal
    GM1552938Courtesy of GENERAL MOTORS CORP.
  6. Remove the pump slide (203), pump slide support seal (208) and the pump slide seal (209).
  7. Remove the slide seal back-up O-ring seal (202) and the oil seal - slide to wear plate, ring (201).
  8. Remove the pivot slide pin (205) and the pivot pin spring (204).
scientia non olet · About LEMON Manuals