LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1669 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Camshaft Position Actuator Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Special Tool & Bolts
    GM1658136Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the J 42386-A  (1) and bolts. See Special Tools . Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation. Tighten the J 42386-A  bolts to 50 N. See Special Tools .m (37 lb ft).
  2. Remove the camshaft position (CMP) actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement .
    3. Fig 2: View Of CMP Actuator Solenoid Valve
    GM1670622Courtesy of GENERAL MOTORS CORP.
    WARNING: Refer to Camshaft Position Actuator Removal and Installation Warning .
  3. Remove the CMP actuator solenoid valve (234).
  4. Discard the solenoid valve.
scientia non olet · About LEMON Manuals