Conditions for Running the DTC
WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
P0601, P0604
- The ignition is in Run or Crank.
- These DTCs run continuously when the above condition is met.
P0602, P0603, P062F
- The ignition is in Run or Crank.
- These DTCs run once per ignition cycle.
P0606, P0607
- The ignition switch is in Run or Crank positions.
- The system voltage is more than 6.0 V.
- These DTCs run continuously when the above conditions are met.
P060D
- The ignition switch is in Run or Crank.
- The system voltage is more than 6.0 V.
- Reduced engine power is inactive.
- DTCs P2120, P2122, P2123, P2125, P2127, P2128, P2138 are not set.
- DTC P060D runs continuously when the above conditions are met.
P16F3
- The ignition is ON or the engine is operating.
- DTC P16F3 runs continuously when the above condition is met.
P2610
- The intake air temperature is between -40 to +125°C (-40 to +257°F).
- DTC P2610 runs on ECM Power Down.