LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1655 (Engine Control System & Fuel System - Hybrid (Hp2) 6.0L (LZ1) - DTC P0315 To DTC P1255/DTC P064A) >> DTC P0324, P0325, P0326, P0327, P0328, P0330, P0332, or P0333 >> Circuit/System Testing >> P0325, P0326, P0327, P0328, P0330, P0332, P0333

P0325, P0326, P0327, P0328, P0330, P0332, P0333

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the affected KS.
  2. Ignition OFF. Connect a DMM to both KS signal circuits, terminals A and B, at the KS. Set the DMM to the 400 mV AC scale, select the Hz mode. Let the reading stabilize at 0 Hz.
    3. NOTE: DO NOT tap on plastic engine components.
  3. Tap on the engine block with a non-metallic object near the affected KS and observe the DMM for a fluctuating frequency.
    • If the DMM does not display a fluctuating frequency while tapping on the engine block then replace the affected KS.
  4. Verify the affected KS is properly tightened, refer to Fastener Tightening Specifications .
  5. Ignition OFF, with appropriate length jumper wires, connect the KS1 harness to the KS2 sensor and the KS2 harness to the KS1 sensor.
  6. Monitor the DTCs using a scan tool. Operate the vehicle within the conditions for running the DTC. Verify the fault does not follow the sensor in question.
    • If the fault follows the sensor in question, replace the appropriate KS.
  7. Ignition OFF, remove the jumper wires from the previous step.
  8. Measure for 2-3 volts between each of the following circuits and ground on the ECM side of the harness connector:
    • The KS signal circuit, terminal A
    • The KS signal circuit, terminal B
    • If less than the specified range, test the circuits for a short to ground or an open/high resistance. If the circuits test normal, replace the ECM.
    • If greater than the specified range, test the circuits for a short to voltage. If the circuits test normal, replace the ECM.
  9. Test for intermittent or poor connections at the ECM, KS, and in-line connectors where present.
  10. If all circuits test normal, replace the ECM.
scientia non olet · About LEMON Manuals