Conditions for Running the DTC
WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
P0133
- DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The Engine Coolant Temperature (ECT) Sensor parameter is more than 60°C (140°F).
- The Intake Air Temperature (IAT) Sensor parameter is more than -40°C (-40°F).
- The Ignition 1 Signal parameter is between 10-18 volts.
- The Fuel Level Sensor parameter is more than 10 percent.
- The Engine Run Time parameter is more than 160 seconds.
- The Engine Speed parameter is between 1,200-3,000 RPM.
- The Barometric (BARO) Pressure parameter is more than 70 kPa.
- The Mass Airflow (MAF) Sensor parameter is between 20-55 g/s.
- The Loop Status parameter is Closed.
- The Throttle Position (TP) Indicated Angle parameter is more than 5 percent.
- DTC P0133 runs once per drive cycle when the above conditions are met.
P0134
- DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The Ignition 1 Signal parameter is between 10-18 volts.
- The engine run time is more than 300 seconds.
- DTC P0134 runs continuously when the above conditions are met.
P013A
- DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271, P2A00 are not set.
- The system voltage is between 10-18 volts.
- The learned heater resistance is valid.
- The fuel level is more than 10 percent.
- The engine run time is equal to or more than 5 minutes.
THEN
- DFCO is active.
- The accelerator pedal (APP) is stable.
- The torque converter clutch (TCC) is locked.
- DTCs P013E, P014A, P2270, and P2272 has run and passed.
- This DTC runs once per trip.
P013B
- DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271, P2A00 are not set.
- The system voltage is between 10-18 volts.
- The learned heater resistance is valid.
- The fuel level is more than 10 percent.
- The engine run time is equal to or more than 5 minutes.
THEN
- DTCs P013A, P013C, P013E, P013F, P014A, P014B, P2270, P2271, P2272, and P2273 have run and passed.
- This DTC runs once per trip.
P013E
- DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271, P2A00 are not set.
- The system voltage is between 10-18 volts.
- The learned heater resistance is valid.
- The fuel level is more than 10 percent.
- The engine run time is equal to or more than 5 minutes.
THEN
- DFCO is active.
- The APP is stable.
- The TCC is locked.
- DTCs P2270 and P2272 has run and passed.
- This DTC runs once per trip.
P013F
- DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271, P2A00 are not set.
- The system voltage is between 10-18 volts.
- The learned heater resistance is valid.
- The fuel level is more than 10 percent.
- The engine run time is equal to or more than 5 minutes.
THEN
- DTCs P013A, P013C, P013E, P014A, P2270, P2271, P2272, and P2273 have run and passed.
- This DTC runs once per trip.
P0140
- DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The Ignition 1 Signal parameter is between 10-18 volts.
- The Engine Run Time parameter is more than 200 seconds.
- The Loop Status parameter is closed.
- DTC P0140 runs once per drive cycle when the above conditions are met.
P1133
- DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The ECT Sensor parameter is more than 60°C (140°F).
- The Engine Speed parameter is between 1,200-3,000 RPM.
- The Ignition 1 Signal parameter is between 10-18 volts.
- The Engine Run Time parameter is more than 160 seconds.
- The Loop Status parameter is Closed.
- The TP Indicated Angle parameter is more than 5 percent.
- The Fuel Level Sensor parameter is more than 10 percent.
- The BARO Pressure parameter is more than 70 kPa.
- The MAF Sensor parameter is between 20-55 g/s.
- DTC P1133 runs once per drive cycle when the above conditions are met.
P2270
- DTCs P0036, P0037, P0038, P0137, P0138, P0140, P0141, P0443, P0458, P0459, P2232 are not set.
- The Ignition 1 Signal parameter is between 10-18 volts.
- The Engine Run Time parameter is more than 5 minutes.
- The Engine Speed parameter is between 1,100-2,500 RPM.
- The MAF Sensor parameter is between 3-20 g/s.
- The Vehicle Speed parameter is between 50-120 km/h (31-75 mph).
- The Fuel Level Sensor parameter is more than 10 percent.
- The Loop Status parameter is Closed.
- The Catalytic Converter Temperature parameter is between 550-900°C (1,022-1,652°F).
- DTC P2270 runs once per drive cycle when the above conditions are met.
P2271
- DTCs P0036, P0037, P0038, P0137, P0138, P0140, P0141, P0443, P0458, P0459, P2232 are not set.
- The Ignition 1 Signal parameter is between 10-18 volts.
- The Engine Speed parameter is between 500-5,000 RPM.
- The MAF Sensor parameter is between 3-50 g/s.
- The Vehicle Speed parameter is between 24-132 km/h (15-82 mph).
- The Fuel Level Sensor parameter is more than 10 percent.
- The Loop Status parameter is Closed.
- DTC P2271 runs once per drive cycle when the above conditions are met for 1 second.