LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1628 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Camshaft Position Actuator and Solenoid Valve Diagnosis and Testing

Camshaft Position Actuator and Solenoid Valve Diagnosis and Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the engine oil level. Fill, as required.
  2. Using the scan tool, inspect for diagnostic codes within the engine control module (ECM). Refer to Diagnostic System Check - Vehicle . Repair, as required.
  3. Verify proper engine oil pressure and operation of the active fuel management oil pressure relief valve. Refer to Oil Pressure Diagnosis and Testing .
  4. Inspect the CMP actuator solenoid valve for proper operation. Refer to Camshaft Position Actuator Solenoid Valve Inspection (On-Vehicle) or Camshaft Position Actuator Solenoid Valve Inspection (Off-Vehicle) .
    • If valve inspection confirms proper movement of the spool, replace the CMP actuator and CMP valve.
    • If valve inspection confirms improper movement of the spool, replace only the CMP valve.
  5. Verify proper operation of the CMP actuator control system. Refer to Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals