LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1610 (Automatic Transmission - 2ML70 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Park Pawl and Actuator Replacement

Park Pawl and Actuator Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Park Pawl & Actuator
GM1970169Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the manual shift shaft position switch. Refer to Manual Shift Shaft Position Switch Replacement .
  2. Remove the rear case. Refer to Rear Case and Gasket Replacement .
  3. Remove the park pawl cover. Refer to Park Pawl Cover and Gasket Replacement .
1 Park Pawl Shaft Hole Plug
2 Park Pawl Shaft
3 Park Pawl Actuator Guide Pin
4 Park Pawl
5 Park Pawl Spring
6 Park Pawl Actuator Guide
Tip:  Push the park pawl into housing in order to remove the park pawl actuator guide.
7 Park Pawl Actuator