Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Replacement - Rear

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing - Rear

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Ensure the bearing is installed squarely into the bearing bore.
1	Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly Tip: Ensure the printing on the bearing is facing upward. A suitable adapter is required to use with the J 8092: driver to install. Press the bearing until the bearing bottoms on the rear case half. Special Tools: J 8092: Universal Driver For equivalent regional tools, refer to Special Tools .