Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Replacement - Front

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing - Front

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Ensure the bearing is installed squarely into the bearing bore.
1	Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly Tip: Ensure the printing on the bearing is facing upward. A suitable adapter is required to use with the J 8092: driver. Press the bearing until the bearing bottoms on the front case half. Special Tools J 2619-01: Slide Hammer J 8092: Universal Driver J 44737: Shift Rail Bearing Remover For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Preliminary Procedure:
Ensure the bearing is installed squarely into the bearing bore.

Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly
Tip:

Ensure the printing on the bearing is facing upward.
A suitable adapter is required to use with the J 8092: driver.
Press the bearing until the bearing bottoms on the front case half.

Special Tools

J 2619-01: Slide Hammer
J 8092: Universal Driver
J 44737: Shift Rail Bearing Remover

For equivalent regional tools, refer to Special Tools .