Transfer Case Rear Case Half Removal

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transfer Case Rear Case Half

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Transfer Case Bolts (Qty: 17)
2	Transfer Case Bracket
3	Transfer Case Rear Case Half CAUTION: Refer to Machined Surface Damage Caution . Tip: Use opposing pry bars at casting bosses to spread case. Use snap ring pliers to release the transfer case rear output shaft outer retaining ring from the transfer case rear output shaft rear bearing assembly.
4	Transfer Case Two/Four Wheel Drive Actuator Seal