Rear Output Shaft Seal and Shift Detent Plunger Assembly Installation
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Transfer Case Rear Output Shaft Seal (Heavy Duty and Super Heavy Duty) Procedure: Align the notch on the seal between the rear output bearing retaining ring access holes. This will position the weep hole down. Special Tools
For equivalent regional tools, refer to Special Tools . |
| 2 | Transfer Case Shift Detent Plunger |
| 3 | Transfer Case Shift Detent Spring |
| 4 | Transfer Case Shift Detent Plunger Plug Seal Procedure: Lightly lubricate the O-ring with clean DEXRON®VI. |
| 5 | Transfer Case Shift Detent Plunger Plug
CAUTION:
Refer to Component Fastener Tightening Caution
.
Tighten: 20 N.m (15 lb ft) |