Access Hole Plugs, Fill and Drain Plug, Vent, 2/4 Wheel Drive Actuator, and Vehicle Speed Sensor Installation
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Transfer Case Two/Four Wheel Drive Actuator Assembly |
| 2 | Transfer Case Two/Four Wheel Drive Actuator Bolt/Screw
CAUTION:
Refer to Fastener Caution
.
Tighten: 18 N.m (13 lb ft) |
| 3 | Transfer Case Oil Fill Plug Procedure: Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the oil fill plug before installation. Tighten: 18 N.m (13 lb ft) |
| 4 | Transfer Case Oil Drain Plug Procedure: Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the oil drain plug before installation. Tighten: 18 N.m (13 lb ft) |
| 5 | Transfer Case Vent Procedure: Apply retaining compound GM P/N 12377901 (Canadian P/N 10953504) to the vent pipe before installation, if removed during disassembly. |
| 6 | Vehicle Speed Sensor (VSS) O-Ring Seal Procedure: Lightly lubricate the O-ring with clean DEXRON®VI. |
| 7 | VSS Assembly Tighten: 17 N.m (13 lb ft) |
| 8 | Transfer Case Access Hole Plugs (Qty: 2) |