LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1604 (Engine Control System & Fuel System - Hybrid (Hp2) 6.0L (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister Vent Solenoid
    GM1855651Courtesy of GENERAL MOTORS CORP.
  1. Position and install the EVAP canister vent solenoid to the vehicle.
    2. Fig 2: Canister Vent Solenoid Retainer
    GM1854543Courtesy of GENERAL MOTORS CORP.
  2. Slide the EVAP canister vent solenoid onto the bracket towards the driver side of the vehicle.
  3. Ensure that the EVAP canister vent solenoid engages the fuel tank bracket retainer (1).
    4. Fig 3: Solenoid Pipe Clip, Canister Pipe Quick Connect Fitting & Canister Vent Solenoid Pipe Quick Connect Fitting
    GM1854542Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP vent solenoid pipe quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Install the EVAP vent solenoid pipe clip (1) to the frame crossmember.
    6. Fig 4: EVAP Canister Vent Solenoid Clip & EVAP Canister Vent Solenoid Pipe Clip
    GM1855649Courtesy of GENERAL MOTORS CORP.
  6. Connect the chassis wiring harness electrical connector to the EVAP canister vent solenoid.
  7. Install EVAP canister vent solenoid clip (1) to the chassis EVAP line.
  8. Install the EVAP canister vent solenoid pipe to the clip (2) on the chassis EVAP line.
  9. Install the EVAP canister vent solenoid pipe to the clips (3) on the brake pipes.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals